Table of Contents
Advertisement
4 Web-based Switch Configuration
Click Apply to make the configurations take effect or click Refresh to redisplay the table.
PoE > PoE System Settings (DGS-2000-10P/10MP/28P/28MP/52MP only)
This PoE System Settings page will display the PoE status including System Budget Power, Support Total
Power, Remainder Power, and The ratio of system power supply.
System Power Threshold: Manually configure the system power budget 7.1 ~ 193.0 watts for DGS-2000-
28P/ME.
PoE LeacyPD Detection: Specifies the legacy PDs detection status.
System Setting Disconnect Method: Defines the method used to deny power to a port once the threshold
is reached. The possible fields are:
Deny next port: When the power budget is exceeded, the next port attempting to power up is
denied, regardless of the port priority.
Deny low priority port: The port with the lower priority will be shut down to allow the higher priority
port to power up.
Click Apply to make the configurations take effect.
LLDP > LLDP Global Settings
LLDP (Link Layer Discovery Protocol) provides IEEE 802.1AB standards-based method for switches to
advertise themselves to neighbor devices, as well as to learn about neighbor LLDP devices. The switch will
keep the information in the Management Information Base (MIB). SNMP utilities can learn the network
topology by obtaining the MIB information in each LLDP device. The LLDP function is enabled by default.
Class 2: Specifies that the power limit will be set to 7W
Class 3: Specifies that the power limit will be set to 15.4W
Class 4: For 802.3at compliance PD devices. Supports up
to 30W in this class.
User Define: Maximum supports to 30W
Note: For the PoE Port Settings table, if the
classification was shown as "Legacy PD", it will be
classified to non-AF PD or Legacy PD.
Note: The ports 1-4 are capable of feeding power
up to 30 watts to devices with the LLDP-Med
function is enabled of the connected PD. Or the
ports can only feeding power up to 15.4 watts.
Figure 4.177 – PoE > PoE System Settings
1
1
1
1
8
8
D-Link DGS-2000 Series Ethernet Switch User Manual
Advertisement
Table of Contents
