Table of Contents
Advertisement
Interfaces and connectors
LAN connectors
On this system board you will find two LAN controllers: a single-channel Gigabit
LAN controller and a service LAN controller.
The single-channel Gigabit LAN controller supports the transfer rates of
10 Mbit/s, 100 Mbit/s and 1 Gbit/s. The Service LAN controller supports the
transfer rates of 10 Mbit/s and 100 Mbit/s.
The LAN controllers support WOL function through Magic Packet™.
It is also possible to boot a device without its own boot hard disk via LAN. Intel
PXE or iSCSI Boot can be used.
The LAN1 port serves as management interface and is prepared for
RemoteView.
The LAN connectors are equipped each with two LEDs (light emitting diode)
indicating the transfer rate and the activity.
Figure 7: LAN connector single-channel Gigabit LAN controller
1 LAN transfer rate green +
2 LAN link/activity
26
2
off
yellow
green
on
yellow
on
green
on
off
flashing
Technical Manual
1
transfer rate 10 Mbit/s
transfer rate 100 Mbit/s
transfer rate 1000 Mbit/s
LAN connection
no LAN connection
LAN transfer
Features
D2509 (TX200 S4)
Advertisement
Table of Contents
