Internal Battery Replacement - Tripp Lite SmartOnline SUPDMB5 Owner's Manual

Internal Battery Replacement

Battery Replacement Door: Under normal conditions, the original battery in your UPS will last several years. However, if batteries
need to be replaced, the internal battery trays are hot-swappable. Battery replacement should be performed only by qualified
service personnel. Refer to "Battery Warnings" in the Safety section. Replacement batteries can be found at
tripplite.com/support/battery/index.cfm. See the chart below to find the right replacement battery for your UPS system:
UPS Model
SU5KRT3PM
SU5KRT3PMP
SU6KRT3PM
SU6KRT3PMP
See the following diagrams for battery removal and installation procedures.
1
Remove the six front screws from the front bezel, then remove
the bezel from the UPS. Hang the bezel on the available hook.
1
3
Open the battery door.
3
5
Once the communication cables have been disconnected.
Remove both old battery trays from the UPS.
Replacement Battery Cartridge
RBC58-3US
RBC58-3US
RBC58-3US
RBC58-3US
2 Loosen the two captive screws securing the battery door.
2
4
Using the handles attached to each tray, pull out the old battery
trays slightly and disconnect the communication cables.
4
5
37