Sharp 1490 Installation Instructions Manual page 5

(B) HORIZONTAL EXHAUST: Outside Ventilation
1. Remove and save 2 screws from back edge and 1 screw from the top center of Fan Cover Bracket.
Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket,
as shown in Figure 9.
2. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. See Figure 10. CAUTION: Do not pull or
stretch hood fan wiring.
3. Rotate the Hood Fan Unit and turn end-over-end so that the fan blade openings are facing the back of the
oven. Replace Hood Fan Unit into the oven. Be careful not to pinch the lead wire between the inner brack-
et and the Hood Fan Unit. See Figure 11.
4. Put the lead wire into Wire Box. See Figure 12.
5. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan
Cover Bracket. Make sure the fan blades are visible through the rear openings in the oven before
proceeding. Attach Fan Cover Bracket to unit with 3 screws, which were removed in Step 1 above. See
Figure 12. The Hood Fan Unit is now rotated for horizontal exhaust operation.
6. Attach the Exhaust Damper Assembly 8 to the back of the Mounting Plate by sliding it into the slits in
the same direction as the arrow. See Figure 13. Use Tapping Screw 4 X 12 7 from the INSTALLATION
HARDWARE and tighten into place.
Fan Cover Bracket
Back of
Oven
Figure 9
Figure 11
Exhaust Damper Assembly 8
Figure 13
Mounting Plate
Tapping Screw 7
Figure 10
Figure 12
(Back Side)
5
Wire Box