Honeywell HAQSPA-R - Air Quality Monitor Quick Start Guide Step by Step

Use

Step 1. Use microUSB cable to charge device.

Step 2. Turn the device on by pressing and holding start button on top for 5 seconds.

Step 3. Download and install the Honeywell IAQ smartphone app using QR code, or directly from App Store.
iOS



Android

Step 4. Connect your smartphone to the WiFi. Launch app and follow instructions to connect the device.

Attention

• The device should be charged for 24 hours continuously the first time you use it so that it can be initialized.
• As a protective measure, the powered off device will continue to provide a weak current to the sensor. Even if fully charged, the device will drain the power if it is not used for a long period of time and must be recharged before being used again.
• When charged, the device will have a slightly higher temperature even at a low power level. Under temperature - variable condition, the device needs 30 minutes to respond and show accurate temperature.
• Note when detecting formaldehyde/TVOC: Due to its packaging, the device will display a higher reading when in use for the first time, which is normal. The device may be placed in a wellventilated area until the reading drops down to 0.08 ppm before use. The formaldehyde/TVOC sensor is an electrochemical sensor. Due to the effects from its electrochemical properties, detection of