Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux REX CA 962 ALU
Summary of Contents for Electrolux REX CA 962 ALU
- Page 1 Cappa Aspirante Cooker hood CA 962 ALU...
-
Page 2: Table Of Contents
Contenuti - Contenents Generalità ..........General Data ..........Componenti ..........Components ..........Avvertenze per la Sicurezza ...... Safety Warnings ......... Installazione ..........Installation ..........• Scelta del tipo di installazione • Selecting the type of installation • Installazione del corpo cappa C •... - Page 3 Contenuti - Contenents Avvertenze per la Sicurezza ....Safety Warnings ........Uso ............Operation ..........Manutenzione ........... Maintenance ..........• Filtri antigrasso metallici • Metal antigrease filters • Filtri al carbone attivo • Activated carbon filters • Illuminazione • Light •...
-
Page 4: General Data
Part 1 - INSTALLATION INSTRUCTIONS 1 - GENERAL DATA This hood has been designed to be wall-mounted above a cooking hob with one side resting against a wall. It works either by suction (external outlet) or filter (internal recycling). Because of the complexity and weight of the hood, its installation should be carried out by qualified staff, taking care to respect all local regulations on air discharge. -
Page 5: Installation
Part 1 - INSTALLATION INSTRUCTIONS 3.8 - Before carring out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 3.9 - If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. - Page 6 Part 1 - INSTALLATION INSTRUCTIONS 4.2 - Installation of the hood canopy C 1 - Drilling the wall a) Using the cardboard template provided, mark on the wall the centres of holes 1 for fixing of the hood canopy C. The centre of hole 2 for fixing the chimney, (fig. 5a) air outlet directed upwards or towards the wall, (fig.
- Page 7 Part 1 - INSTALLATION INSTRUCTIONS 3 - Fitting the hood canopy C to the wall a) Remove the lower grill and the active charcoal filter if present (see paragraph on maintenance). b) Fit the support rod B using the two screws K (3,5x9,5) provided (fig.
- Page 8 Part 1 - INSTALLATION INSTRUCTIONS 1 - Drilling the shelves: S36_12 a) Using the cardboard template provided, and taking hole “B” as a point of reference, drill the shelves along the central axis to allow the passage of the chimney. The chimney must be inserted into the shelves before it is fixed to the hood canopy C (fig.
- Page 9 Part 1 - INSTALLATION INSTRUCTIONS - Remove the plug from the upper part of the ducting fan unit (fig. 17), as it is not possible to insert the flange F with the plug in place. - Fit the flange F Ø120 or 150 mm (fig. 18), replace the plug. ·...
- Page 10 Part 1 - INSTALLATION INSTRUCTIONS 4.4 - Ducting or recirculation fitting 1 - Ducting fitting. This is possible for all forms of installation: a) Connect the air outlet to the external ducting system. b) Remove the activated charcoal filter (if there is one) inside the hood canopy (see Maintenance).
- Page 11 Part 2 - USE AND MAINTENANCE INSTRUCTIONS 1 - SAFETY WARNINGS It is most important that all the warnings shown in paragraph 3 of the Installation Instructions are strictly observed. Moreover, pay special attention to the following warnings during the use and maintenance of the cooker hood: 1.1 - The grease filters and charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (over 4 hours per day).
- Page 12 Part 2 - USE AND MAINTENANCE INSTRUCTIONS 3.1 - Metal antigrease filters 1 - Cleaning It is necessary to wash these filters at least every two months with a normal detergent; their compact size enables them to be washed also in dishwasher. 2 - Replacement S36_29 Remove the metal grease filter by removing...
- Page 15 4329410_02 - 040122...