Table of Contents
Advertisement
1
Safety information
When a problem occurs
• Should any of the following occur, immediately turn OFF the power to each piece
of equipment, unplug the power cord from the AC outlet, and contact your sales
representative or local Canon dealer:
– When there is smoke, an odd smell or abnormal sound
– When liquid has been spilled into the equipment or a metal object has entered through an
opening
– When the equipment has been dropped and is damaged
Inspection, disinfection, and cleaning
• Do not use flammable solvents to clean the surface of the equipment.
When the equipment is going to be cleaned, be sure to turn OFF the power to each piece
of equipment, remove the battery pack, and unplug the power cord from the AC outlet.
Never use benzine, thinner or any other flammable solvents. Otherwise, it could result in
fire.
• Clean the plug of the power cord periodically by unplugging it from the AC outlet
and removing dust or dirt from the plug, its periphery and AC outlet with a dry
cloth.
If the cord is kept plugged in for a long time in a dusty, humid or sooty place, dust around
the plug will attract moisture, and this could cause insulation failure that could result in a
fire.
• After every examination, wipe the patient contact surfaces of the detector using
a disinfectant such as disinfecting ethanol to prevent the risk of infection.
A blood infection or other causes may result in the onset of an infectious disease. For
details on how to disinfect, consult a specialist.
• Do not spray the detector directly with disinfectants or detergents.
• Always keep this product and other equipment clean and remove all dust and
dirt.
Dust and dirt may cause malfunctions of the equipment included in the radiography
system, such as this product and computers.
• When cleaning the battery pack, wipe it with a cloth slightly damped with water
or diluted neutral detergent.
The battery pack is not protected against liquids. When cleaning the battery pack, wipe it
carefully so as not to spill the detergents onto the electrodes.
• Dry the battery pack completely after cleaning, and attach it to the equipment.
• When cleaning any other parts than the sensor side of the detector, wipe them
carefully so as not to spill the detergents onto the battery pack attachment
portion (electrodes).
• Use water or diluted neutral detergent to clean the surface of the detector and
other equipment. Do not use paint thinner, benzine, or chlorinated solvents.
Doing so may damage the surface of the detector or other equipment.
• Dry the detector completely after disinfecting or cleaning it.
8
Advertisement
Table of Contents
