Care And Cleaning - KitchenAid 5KES6403 Owner's Manual

PROGRAMMING FUNCTION (CONTINUED)
PROGRAMMING THE WATER TEMPERATURE AND WATER
HARDNESS
1.
To change pre-programmed Water Temperature: Toggle the Mode Button to select
Espresso, press and hold for 3 seconds. The indicator lights will show the default factory
setting or previous saved setting (see Indicator light chart for reference). Toggle the Mode
Button between Low-Mid- High to select desired temperature. To save your selection,
press Button or wait for 10 seconds.
2.
To change pre-programmed Water Hardness: Toggle the Mode Button to Water, Press
and hold for 3 seconds. The indicator lights will show the default factory setting or previous
saved setting (see Indicator light chart for reference). Toggle the Mode Button between
Low- Mid-High to select desired Water Hardness. To save your selection, press
or wait for 10 seconds.
INDICATOR LIGHT CHART
WATER
TEMPERATURE OR
WATER HARDNESS
Low
Medium
High
NOTE: Water Hardness - Low: 0 to 60 ppm
Medium: 60 to 120 ppm
High: more than 120 ppm
TIP: To restore all factory settings, Press and Hold "Dose Button" for 3 seconds. All indicator
lights will blink indicating that all settings are restored.

CARE AND CLEANING

For best results, regularly clean the Espresso Machine and accessories.
IMPORTANT: Unplug the Espresso Machine before cleaning. Allow the appliance to cool
completely before putting on or taking off parts, and before cleaning the appliance.
NOTE: Do not use abrasive cleansers or scouring pads when cleaning the Espresso Machine,
parts, or accessories. Do not immerse the Espresso Machine or cord in water or other liquids.
1.
When the Drip Tray Indicator rises and becomes visible above the surface of the Drip Tray
Plate, empty the Drip Tray and rinse with warm water.
2.
Wipe the Espresso Machine housing and Group Head with a clean soft damp cloth.
3.
Wash the Drip Tray, Portafilter, Filter Baskets, Milk Pitcher, and Drip Tray Plate in warm,
soapy water and rinse with clean water. Dry with a soft cloth.
4.
Clean the Steam Wand after every use. Toggle the Mode Button to select Water. Position
the Steam Wand over Drip Tray or into a cup. Press
Press Button to stop. Wipe down wand exterior with a soft damp cloth.
NOTE: To remove the Steam Wand press the Steam Wand Release Button.
Button, wait 3 to 5 seconds.
Button
7