Stylus And Tether; Removing The Stylus And Tether; Installing The Stylus And Tether; Battery - Dell Latitude 14 Rugged 5414 Series Owner's Manual

Table of Contents

Stylus and tether

1. Pull the stylus out from the slot on the computer [1].

2. Release and remove the tether from the computer [2].

1. Install the tether to the computer.

2. Insert the stylus into the slot and push it inwards.

Your system ships with a non-hot swappable battery. You also have an option to select a hot swap battery.

NOTE:

The battery is a FRU.

To check if your battery is a hot swap battery, go to System Setup > General > System Information screen. The battery

is not a customer replaceable part. If the hot swap battery is installed, the optical drive is removed.

Hot swap battery

This section explains what happens when you swap the battery.

The BIOS allows 1 minute to swap the hot swap battery if there is sufficient charge and the temperature is 0º–60º C. When

swapping the battery, the LCD, backlight and all LEDs turn off and the processor enters a low power state to reduce system

power. The battery LED flashes green/amber (once per second) for the first 45 seconds. For the last 15 seconds, the green/

amber flashes at a faster rate to indicate that the swap time limit is near. If the 1-minute time is exceeded, the unit attempts to

enter the Sleep (S3) state. If the user has disabled S3 or the OS fails to enter S3 entering Sleep is not guaranteed. When the

Disassembly and reassembly

Table of Contents