Appliance Electric Connection - Omega OF914FX Instruction Manual

APPLIANCE ELECTRICAL CONNECTION
The electric connection must comply with the current legal standards and regulations.
Before making the connection, check that:

The system electrical rating and the current outlet are adequate for the maximum power output of the appliance (see the
label applied to the bottom of the casing).

The outlet or the system is equipped with an efficient ground connection in accordance with the current legal standards and
regulations. The manufacturer will not be responsible for the non-compliance with these instructions.

The power cord is supplied with a 15A plug, suitable for the load indicated on the label and a standard 15A GPO.
Letter L (phase) =brown wire;
Letter N (neutral) = blue wire;
Ground symbol =green-yellow
wire;

The power cord must be positioned so that a temperature of 75°C will not be reached at any point.

Do not use reductions, adapters or splitters since they might cause false contacts and lead to dangerous
overheating.
When the connection is made directly to the electric network:

Use a device that ensures disconnection from the mains in which the contacts are opened to a distance that permits
complete disconnection according to the conditions for over-voltage category III.

The ground wire must not be interrupted by the circuit-breaker.

As an alternative, the electric connection can also be protected by a high-sensitivity residual current circuit- breaker
but this may be subject to nuisance tripping due to residual humidity in heating elements.

It is highly recommended to attach the special green-yellow ground wire to an efficient ground system.
WARNING:
If the power cord is replaced, the ground w i r e (yellow-green) connected to the terminal, should be
longer than the other wires by about 2 cm.
WARNING:
if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard.
Work surface
operation
Only gas burner
The appliance conforms to the regulation AS/NZS5263 regarding gas appliance for domestic use and
AS/NZS60335.26 regarding safety and CSPR 14 regarding electromagnetic compatibility.
TABLE N°3: TYPES OF POWER CORDS
Oven
operation
Gas oven / Electric grill
Ventilated Electric Oven
Fig. 14
Cross section
230V ~ 230V 3~
3x1mm² -
3x1,5mm² -
10
400V 2N~ 400V 3N~
- -
- -