1. Manuals
  2. Brands
  3. Omega Manuals
  4. Cookers
  5. OF914FX
  6. Instruction manual

Omega OF914FX Instruction Manual

Free-standing cookers 90x60 cm
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUAL FOR OMEGA
FREE-STANDING COOKERS
90x60 cm – OF914FX, OF916FX

Advertisement

Table of Contents
loading

Related Manuals for Omega OF914FX

Summary of Contents for Omega OF914FX

  • Page 1 INSTRUCTION MANUAL FOR OMEGA FREE-STANDING COOKERS 90x60 cm – OF914FX, OF916FX...

  • Page 3: Table Of Contents

    The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance. Due to continual product development, Omega reserves the right to alter specifications and appearances without notice.

  • Page 4: Warnings

      WARNINGS:   This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

  • Page 5: Local Authority Requirements

      LOCAL AUTHORITY REQUIREMENTS   Before installation, unpack all parts from carton, remove all internal packaging and check for damage. Check Gas Type and specifications plate placed on the rear of the unit, alternatively there is a second label supplied – this should be fixed in an accessible position close to the appliance (on the side of a cabinet, etc.).

  • Page 6: Important Information For Installing The Appliance

        IMPORTANT INFORMATION FOR INSTALLING THE APPLIANCE   The cooker can be installed separately, a s a freestanding unit, or between kitchen u nits or between a kitchen unit and the wall.   This appliance is not connected to devices which exhaust combustion products.  ...

  • Page 7: Appliance Gas Connection

       APPLIANCE GAS CONNECTION   IMPORTANT: This appliance must be installed by an authorised person.   WARNING: DO NOT MODIFY THIS APPLIANCE If the appliance cannot be adjusted to perform correctly, contact the service department. This appliance utilises a threaded 1/2" gas male fitting. To connect the appliance to the gas network with a flexible hose, a supplemental hose nipple fitting is needed which is supplied with the appliance.
  • Page 8 Check correct operation of the ignitions system and operation of the regulator and operation of the burners individually and in combination. Burner flames should be clear blue, with no yellow tipping. If the burners show any abnormality check that the burners are correctly located. If satisfactory performance cannot be obtained, contact Omega service. Important Before leaving instruct the owner in the use of the cooker it should be expressly noted that we cannot accept any liability for direct or indirect damage caused by wrong connection or improper installation.

  • Page 9: Support Legs

    SUPPORT LEGS The cookers are supplied with four transit supports (one for each corner). Four support legs are supplied separately and are fitted on location to the four corners of the lower support frame. Each support leg is pushed over the relevant transit support until flush with the support frame. Each leg is adjusted by screwing the lowe r section in or out as required for fitting to a 900mm bench height.
  • Page 10 With the legs adjusted to a nominal cooker height of 910 mm, and the splash-back fitted, anti-tilt restraint bracket can be added to the rear of the appliance. First fit the flat strap to the rear of the cooker at the centre point of the lower rear edge. Use the supplied screw (Fig. 08). Mark a line on the floor marking the mid-point of the cooker once installed (see Fig.

  • Page 11: Convertion To A Different Type Of Gas

      CONVERSION TO DIFFERENT TYPES OF GAS Before performing any maintenance operation, disconnect the appliance from the gas supply and electricity network. REPLACING THE NOZZLES TO OPERATE WITH ANOTHER TYPE OF GAS When converting to LPG remove the NG gas regulator (if fitted) and fit LPG test point adaptor. If converting to Natural Gas, fit gas regulator.

  • Page 12: Appliance Electric Connection

    APPLIANCE ELECTRICAL CONNECTION The electric connection must comply with the current legal standards and regulations. Before making the connection, check that:  The system electrical rating and the current outlet are adequate for the maximum power output of the appliance (see the label applied to the bottom of the casing).
  • Page 13 Three-Phase electric connection The cookers that can also be connected to three-phase systems normally are factory built for the single-phase 230V connection and are supplied with a power cord. Based on the connection system used, install the power cord type indicated in table No.3. To use the selected connection system change the jumpers on the terminal strip as indicated in the diagram of (Fig.15) Fig.

  • Page 14: Appliance Use And Maintenance

    APPLIANCE U S E A N D MAINTENANCE ATTENTION: Important Warnings.  For cookers resting on base ATTENTION: if the cooker rest on a base, take the measures necessary to prevent the cooker from sliding along the support base.  For cookers with electric ovens ATTENTION: The unit becomes hot during use.
  • Page 15 Indicates the control knob adjusts the internal thermostat of the oven (the light below is lit when the elements are running). Indicates the control knob adjusts the mechanical timer (OF914FX only). WARNING: If the power is cut off, the cook top burners c a n be lit with matches. When cooking foods with oil and fat, which are very flammable, t h e user should n o t leave the appliance unattended.
  • Page 16 10°C less than the temperature setting. The thermostat can control the oven elements only if an oven function has been set. For manual timers (OF914FX), the timer must be set or adjusted to manual mode. For...
  • Page 17 USING THE OVEN FUNCTION CONTROL KNOB (Fig. 20) The oven function knob is used to control the electric fan and the oven elements in set combinations in conjunction with the timer and thermostat. The electric oven is heated by 4 elements: Upper element (1200W) and grill element (1500W) combined at the top of the oven cavity.
  • Page 18 There are 9 functions as per below: QUICK START/DEFROST FUNCTION: This function runs the rear fans and all elements. The heat generated is too hot to cook in, but is perfect for preheating the oven (run at the required temperature until the thermostat light turns off and on a couple of time, then adjusts to the required function setting.
  • Page 19 USING THE ELECTRIC OVEN When using the oven for the first time it should be operated for a maximum of 30 minutes at a temperature of about 250°C to eliminate any odours generated by the internal insulation. During normal oven use, select the desired cooking temperature using the thermostat knob and wait until the orange light turns off (set temperatur e has been reached) before putting in any food.
  • Page 20 USING THE MANUAL TIMER (OF914FX) When not using a timer to cook in the oven, the manual timer control knob should be turned to the manual cooking setting (Hand symbol between 0 and 120). To use the manual timer, place food into the oven and set up functions and temperature as applicable.
  • Page 21 Any liquid that overflows from pots must always be removed using a rag. If it becomes difficult to open or close a valve, do not force it, but immediately contact the omega service department. Cleaning the enamelled parts The trivets and burner covers are cast iron with an enamel coating.

  • Page 22: Troubleshooting

    PROBLEM SOLUTION Oven or hob not working Check the electricity is turned on. Check your fuses. If the fuse continues to blow, call Omega service. Check the circuit breaker. Ensure correct knob is positioned correctly. Dry or clean ignition electrodes.

This manual is also suitable for:

Of916fx

Table of Contents