Advertisement
8.0 INSTALLING THE APPLIANCE - CONTINUED
wall using two of the fixing screws provided. If this is not achievable then the wall
should be strengthened using appropriate building materials.
If there is no alternative than to rely on som plasterboard fixings then special cavity
screw fixings or hollow wall anchors will be required which are not supplied with this
product. These should be constructed from metal and not plastic and of the design
indicated (Figure 2). For further guidance for wall fixing in timber framed buildings
refer to any relevant local codes of practice.
For optimum viewing install the fire out of direct sunlight. Ensure that the bracket
is level by using a spirit level whilst marking out the hole positions. Fix the wall
bracket using the plugs and screws provided. Carefully lift the heater up ensuring
that the top rear ledge of heater engages with the wall bracket and is sitting
centrally.This process should be carried out by two people to avoid injury or
damage to property or the appliance.
Gently bring the heater down against the wall. Mark the lower fixing bracket
oneing hole position on the wall, remove the heater. Drill the wall and insert the
wall plug. Refit the heater to the wall and fasten the bottom fixing bracket to the
wall using the screw provided to permanently fix the heater in place (Figure 3).
The facia panel is supported by four M6 screws which
protrude from the front of the outer casing as shown in
figure 4. Ensure each screw is unscrewed approximately
one turn from the fully screwed in position in order to
create a 2mm gap as shown in figure 5 Simply hang the
facia panel onto the outer casing ensuring that the
corresponding keyhole shaped holes engage the
screwheads fully.
Figure 5
9.0 OPERATING THE APPLIANCE - READ BEFORE USE
The control panel is located underneath the decorative frame on the bottom right hand side of the appliance.
CONTROL PANEL
mm
MAINS POWER ON/OFF
FLAME BRIGHTNESS (5 settings)
Press to adjust the brightness level
FULL (5) - HIGH (4) - MEDIUM (3) - LOW (2) - DIM (1) - (LOOP)
HEATING (7 settings)
Press ∧ / ∨ to adjust the temperature level
60℃/99°F - 30℃/86°F - 28℃/82°F - 26℃/78°F - 24℃/75°F - 22℃/71°F - OFF -
(LOOP) Press button for 10s to convert between ℃ and ℉ (model dependent)
EMBER/FUELBED EFFECT
Press to select the dynamic fuelbed effect
Figure 4
5
Figure 2
Figure 3
©
2016 Smeg (UK) Ltd.
GB IE
Advertisement
