Table of Contents
Advertisement
Chapter 2
(Bluetooth) button function
(RJ-4030Ai only)
Enable or disable the Bluetooth
Auto re-pairing function.
(Wi-Fi) button
function (RJ-4040 only)
Use WPS to set wireless network
settings easily
Use Wi-Fi to communicate when
printing
End the Wi-Fi connection
Start up the printer in mass
storage mode
Execute a file stored in the mass
storage area
Indicators
RJ-4030/RJ-4030Ai
RJ-4040
The indicators light and blink to indicate the printer's status. Each indicator may light or blink in
green, red, orange, or blue. For details, see Indicators uu page 49.
24
Operation
Confirm that the Bluetooth function is turned on.
Press and hold the
(Bluetooth) button for 5 seconds.
If the function is turned off, the
then the printer turns off.
If the function is turned on, the
and then the printer turns off.
Operation
Wi-Fi settings can be configured by simply pressing and holding this
button, making it easy to install the printer driver or other software (see
Installing the Printer Driver and the Software for RJ-4040
uu page 10).
When the printer and computer are not connected via Wi-Fi, press this
button to connect them and send data to the printer.
When the printer and computer are connected via Wi-Fi, press this
button to end the connection.
If you press this button while pressing and holding the
button, the printer starts up in mass storage mode (see Mass Storage
uu page 45).
If you press this button while the printer is running in mass storage
mode, you can execute a command file stored in the mass storage
area (see Mass Storage uu page 45).
(Bluetooth) indicator turns off, and
(Bluetooth) indicator flashes once,
(Power)
2
2
2
Advertisement
Table of Contents
