Advertisement
Parent unit
Install batteries
1.
Lift up the battery cover to remove it from the parent unit.
2. Insert the rechargeable Ni-MH battery cells supplied. Note the '+' and
'-' markings inside the battery compartment and insert in the correct
direction.
3. Place the battery cover back into place.
Connect the parent unit
1.
Plug the DC plug of the power adaptor into the DC jack on the side of the
parent unit and plug the other end of the AC adaptor into the AC power
outlet.
2. Switch on the AC power (if your AC power outlet has a switch). The battery
charging LED indicator lights up in red and turns dim until the batteries are
fully charged.
Note: If the battery charging LED indicator flashes red when turning on the
power button, it means the battery level is low and needs recharging. During
charging, the parent unit and baby unit should not be attached together.
8
Advertisement
