Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, and the feature sticker from the outside of the door,
if there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around
the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate
the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if
necessary.
2. Accessories provided
1 ) Combined operation manual and cookbook
3. This oven can be installed in the locations indicated by the following "checkmarks".
Installation location example
Installation image
Presence or absence of
check mark
Standard conformity number
This oven is designed to be used on a counter top, on a shelf, in a cabinet.
It should not be installed in any area where excessive heat and steam are generated, for example, next to
a conventional oven unit. The oven should be installed so as not to block ventilation openings.
When the oven is mounted on a kitchen countertop, on a shelf or in a cabinet, allow a space of at least
15cm on the top, 10cm on both sides and 5cm at the rear of the oven for adequate air circulation.
Additionally, when installing on a shelf or in a cabinet, the minimum dimension of the shelf or cabinet
should be 695mm ( W ) ×453mm ( H ) ×420mm ( D ) . This oven must be operated with cabinet door open.
Do not built-in the appliance under the counter top or any other appliance.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230-240V, 50Hz.
5. This appliance must be earthed.
6. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven
with non-sinusoidal outputs.
OVEN DIAGRAM
6
3
4 5
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Control panel ( See page 6 )
Countertop
11
2
4
13
On a Shelf
( AS/NZS60335 )
10
8
7
1
8. LED Display
9. Ventilation openings
10. Power supply cord
11. Oven Cavity
12. Outer cabinet
13. Flatbed
5
In a Cabinet
Built-In
9
12
—
—
Advertisement
Table of Contents
