Cisco Threat Grid M5 Maintenance Manual page 2

Remove and Replace a Drive
Step 3
If a maintenance procedure instructs you to completely remove power from the Threat Grid M5, disconnect all power
cords from the power supplies.
Remove and Replace a Drive
Note The drives are hot-swappable. You do not have to shut down the Threat Grid M5 to remove or replace drives.
Note You cannot add more drives to the chassis. You can only replace the drives in the slots that shipped with your
Threat Grid M5.
Before you begin
Take note of the following warnings:
Warning Statement 1018 Supply Circuit
To reduce risk of electric shock and fire, take care when connecting units to the supply circuit so that wiring
is not overloaded.
Warning
Statement 1019 Main Disconnecting Device
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device.
Warning Statement 1024 Ground Conductor
This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Maintenance and Upgrades
2
Maintenance and Upgrades