Switch Action - Makita HS7611 Instruction Manual

► 1 . Clamping screw
Sighting
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
45° position with it.
► 1 . Cutting line (0° position) 2. Cutting line (45°
position)
► 1 . Cutting line (0° position) 2. Cutting line (45°
position)

Switch action

Before plugging in the tool,
WARNING:
always check to see that the switch trigger actu-
ates properly and returns to the "OFF" position
when released.
1
2 1
3 2 1 2
2 1
7 ENGLISH
1
► 1 . Switch trigger 2. Lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
NEVER defeat the lock-off button
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
NEVER use the tool if it runs when
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
Do not pull the switch trigger hard
NOTICE:
without pressing in the lock-off button. This can
cause switch breakage.
ASSEMBLY
Always be sure that the tool is
CAUTION:
switched off and unplugged before carrying out
any work on the tool.
Removing or installing circular saw
blade
Be sure the circular saw blade is
CAUTION:
installed with teeth pointing up at the front of the
tool.
Use only the Makita wrench to
CAUTION:
install or remove the circular saw blade.
1. To remove the circular saw blade, press the shaft
lock fully so that the circular saw blade cannot revolve
and use the hex wrench to loosen the hex bolt counter-
clockwise.
2