Table of Contents
Advertisement
Anti-Scalp Rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
The anti-scalp rollers can be set in three positions:
•
Upper position 1½ to 2½" (38 to 64 mm) grass
•
Middle position 2½" to 4" (64 to 102 mm) grass
•
Lower position 4" to 6" (102 to 128 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely. If wheels do not rotate freely take the unit to
your dealer for service.
Foam filled tires or solid tires will void the warranty.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill
material to the tires. Excessive loads created
by foam filled tires will cause premature
failures.
Only use O.E.M. specified tires.
Removal and installation
1. Remove nut and caster bolt.
2. Pull the wheel out of the yoke and retain the
spacer for reuse.
3. Install in reverse order.
4. Tighten caster bolt.
Hardware
Check daily. Inspect the entire machine for loose or
missing hardware.
42
MAINTENANCE
Anti-scalp rollers
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
1. Caster yoke
2. Caster long spacer
Caster wheels
8050-830
1
2
8011-619-4
Advertisement
Table of Contents
