Table of Contents
Advertisement
22
en | Installing Roof Parapet and Pipe Mounts
2.4
Route Wires and Attach Connectors
Power wires must be routed to the left (front) side of the Power Supply Box through a sepa-
rate conduit. All video, control, and alarm wires must be routed through a second conduit to
the right side of the box. See Chapter 4: Cable and Wire Standards for methods of transmitting
video and data, and for wire specifications.
WARNING! External interconnecting cables are to be installed in accordance to NEC,
ANSI/NFPA70 (for US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN
application) and in accordance to local country codes for all other countries.
!
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
Fig. 2.4 Parapet and Pipe Mount Power Supply Box
There are two possible methods to route the video, control, and alarm wires:
–
One is to route the video, control, and alarm wires through the conduit fitting on the right
(front) side of the Power Supply Box and out to the AutoDome Interface Board.
–
The second method is to bypass the Power Supply Box and route the video, control, and
alarm wires directly to the Interface Board. You connect only the power wires inside the
Power Supply Box.
NOTICE! Fiber Optic Models require that the Biphase control wires be routed from the Power
i
Supply Box P106 connector out to the Pipe Interface Board P105 connector.
F01U010921 | 1.0 | 2006.10
J102
P101
(LED)
LINE NC NEUT
P106
P105
GND TXD RXD
C+ C-
GND TXD RXD
C+ C-
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.
Advertisement
Table of Contents
