Table of Contents
Advertisement
Using the Remote
Using Direct Entry
1.
Turn on the component to be programmed.
2.
Look up the brand and code number(s) for the component on the code list in the
section "Remote Control Codes" on the following page.
3.
Press and hold the remote control button you want to program.
4.
Enter the code from the code list.
5.
Release the button, and then press ON•OFF to see if the component responds to the
remote control commands. If it doesn't, try pressing the component button and then
ON•OFF again.
6.
If you get no response, repeat these steps using the next code listed for your brand
until the component responds to the remote control commands.
Using the Remote to Control a
Component
Once the remote has been programmed successfully, you are ready to use it to
control your components, such as a VCR, DVD player, or laserdisc player.
To operate the component:
1.
Press the component button (VCR1, VCR2, DVD, or AUX) to set the remote to
control the component.
2.
Press ON•OFF to turn the component on or off.
3.
Use the remote control buttons that apply to that component.
This remote control may
not operate all models
of the brands that are
shown. Use the codes
shown in this manual, or
on the sheet packed
with your remote
control.
21
Advertisement
Table of Contents
