Black & Decker CJ4000S - Automatic Citrus Juicer Manual

Overview

1. Storage cover
2. Self-reversing large cone
3. Self-reversing small cone with stirrer
4. Strainer
5. Container
6. Stainless steel snap-up spout
7. Base stem
8. Motor base
9. Cord storage (under unit)

How to Use

This product is for household use only.
Wash all parts as instructed in the CARE AND CLEANING section.

Assembling your juicer
In order to assemble your juicer, follow these steps:

1. Lower the container through the base stem unto the base (A).
   
2. Lower the strainer through the base stem unto the container (B).
   
3. Small cone fits inside the large cone (C).
   Note: When using the large cone place the small cone inside it. The small cone can be used by itself.
   
4. Choose a cone, lower it through the base stem unto the strainer (D).
   

EXTRACTING JUICE

1. Unwrap the cord around the cord wrap underneath the base (E).
   
2. Plug the cord into a standard electrical outlet.
3. Cut fruit in half (orange, lime, lemon or grapefruit).
4. Remove the storage cover from the citrus juicer.
5. Open the snap-up spout by pushing it down.
6. Place a glass under the stainless steel snap-up spout.
   Note: When the juicing action begins, the juice flows directly into the glass.
7. Place the cut side down over the cone (F). Using moderate to firm pressure, press the fruit down to start the juicing action which rotates the cone clockwise until the pressure is released. By applying pressure again the cone rotates counterclockwise.
   Note: The cone changes direction every time you release the pressure and stop pressing the fruit down on the cone.
   
8. For best results, alternate between pressing the fruit down firmly and releasing pressure to extract all the juice from the fruit. Do this several times.
9. The motor stops automatically when you remove the fruit from the cone or if the pressure is completely released.
10. When you finish the juicing action, lift the stainless steel snap-up spout to stop the juicer from dripping (G).
    Note: Always lift the snap-up spout when you are done juicing.
    

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified service personnel.

To Clean

1. Always unplug the unit before cleaning or when not in use.
2. Remove the strainer from the container.
3. To remove the cone from the strainer, turn it and pull out. Rinse the strainer and cone immediately after each use. Use a bristle brush to remove fine pulp that may remain.
4. Use warm, sudsy water to wash all removable parts or place in the dishwasher — top rack ONLY.
5. Wipe the base with a damp cloth or sponge; do not immerse in water or place in the dishwasher.
6. Dry all parts before reassembling your juicer (see ASSEMBLING YOUR JUICER section).

To Store

1. Unplug the unit.
2. Wrap the cord around the base of the unit (E).
3. Before reassembling your juicer, make sure all parts are dry (see ASSEMBLING YOUR JUICER section).
4. Place storage cover over the juicer to keep it dust free.

NEED HELP?
For service, repair or any questions regarding your appliance, call the appropriate 800 number on cover of this book. Please DO NOT return the product to the place of purchase. Also, please DO NOT mail product back to manufacturer, nor bring it to a service center. You may also want to consult the website listed on the cover of this manual.