Table of Contents
Advertisement
AutoDome 700 Series IP PTZ Camera
3.2
Pre-installation Check List
1.
2.
NOTICE!
Power and I/O cabling must be routed separately inside different permanently earthed metal
conduits.
3.
WARNING!
External interconnecting cables are to be installed in accordance to NEC, ANSI/NFPA70 (for
US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance to local country codes for all other countries.
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
4.
5.
CAUTION!
Select a rigid mounting location to prevent excessive vibration to the AutoDome camera.
Bosch Security Systems, Inc.
Determine the location and distance for the power supply box based on its voltage and
current consumption. Refer to Section 5 Cable and Wire Standards, page 57 for wiring
information and distances.
Use only UL listed liquid tight strain reliefs for conduits to the Power Supply Box to
ensure that water cannot enter the box. You must use water tight conduits and fittings to
meet NEMA 4 standards.
Install all rough wiring including: power, control, video coax, alarms I/O, relay I/O, and
fiber optic cabling. Refer to Section 5 Cable and Wire Standards, page 57 for video and
control protocol methods.
Choose the appropriate VG5 AutoDome model (indoor or outdoor) for the environment in
which it will be used.
Purchase the appropriate mounting hardware to use, depending on the location of the
AutoDome and the application.
Installation Manual
Installing the Roof Parapet and Pipe Mounts | en
F.01U.215.779 | 1.0 | 2011.07
31
Advertisement
Table of Contents
