Advertisement

EN
User Manual
F34300VI0
Dishwasher

Advertisement

Table of Contents
loading

Summary of Contents for AEG F34300VI0

  • Page 1 User Manual F34300VI0 Dishwasher...
  • Page 2: Table Of Contents

    12. TECHNICAL INFORMATION..................18 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
  • Page 4: Safety Instructions

    Put knives and cutlery with sharp points in the cutlery • basket with the points down or in a horizontal position. Do not keep the appliance door open without • supervision to prevent to fall on it. Before maintenance, deactivate the appliance and •...
  • Page 5 ENGLISH • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Service • Contact the Authorised Service Centre to repair the appliance.
  • Page 6: Product Description

    3. PRODUCT DESCRIPTION Upper spray arm Rinse aid dispenser Lower spray arm Detergent dispenser Filters Cutlery basket Rating plate Lower basket Salt container Upper basket Air vent 4. CONTROL PANEL On/off button Programme button Programme indicators Delay button Indicators...
  • Page 7: Programmes

    ENGLISH 4.1 Indicators Indicator Description Running programme indicator. It comes on when the programme starts and goes off when the programme is completed. End indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5.
  • Page 8: Settings

    6. SETTINGS 6.1 Programme selection However, if this does not happen, you can set the programme selection mode mode and user mode in the following way: When the appliance is in programme Press and hold the programme button selection mode it is possible to set a until the appliance is in programme programme and to enter the user mode.
  • Page 9: Before First Use

    ENGLISH than 21°dH, you can set the lowest water not possible to deactivate these acoustic softener level. It deactivates the salt refill signals. indicator. There is also an acoustic signal that If you use standard detergent or multi- sounds when the programme is tablets without salt, set the proper completed.
  • Page 10: Daily Use

    7.1 The salt container 7.2 How to fill the rinse aid dispenser CAUTION! Only use salt specifically designed for dishwashers. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use.
  • Page 11 ENGLISH Make sure that the appliance is in 1. Adjust the water softener to the programme selection mode. lowest level. • If the salt indicator is on, fill the 2. Set the rinse aid dispenser to the salt container. lowest position. •...
  • Page 12: Hints And Tips

    Cancelling the programme 1. Press the on/off button to deactivate the appliance. Press and hold the programme button 2. Close the water tap. until the appliance is in programme If you do not deactivate the selection mode. appliance within 5 minutes Make sure that there is detergent in the all indicators goes off.
  • Page 13: Care And Cleaning

    ENGLISH 6. Activate the rinse aid dispenser. • The filters are clean and correctly installed. 9.4 Loading the baskets • The cap of the salt container is tight. • The spray arms are not clogged. • Only use the appliance to wash items •...
  • Page 14 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).
  • Page 15: Troubleshooting

    ENGLISH • If you regularly use short duration • To maintain the performance of your programmes, these can leave appliance at its best, we recommend deposits of grease and limescale to use monthly a specific cleaning inside the appliance. To prevent this, product for dishwashers.
  • Page 16 Problem and alarm code Possible cause and solution The appliance does not drain the wa- • Make sure that the sink spigot is not clogged. ter. • Make sure that the drain hose has no kinks or • The end indicator flashes 2 times bends.
  • Page 17 ENGLISH 11.1 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and basket loading leaflet. • Use more intensive washing programmes. • Clean spray arm jets and filter. Refer to "Care and Cleaning".
  • Page 18: Technical Information

    Problem Possible cause and solution There are residues of deter- • The detergent tablet got stuck in the dispenser and gent in the dispenser at the therefore was not completely washed away by water. end of the programme. • Water cannot wash away the detergent from the dis- penser.
  • Page 19 ENGLISH your local recycling facility or contact marked with the symbol with the your municipal office. household waste. Return the product to...
  • Page 20 www.aeg.com/shop...

Table of Contents