Cisco 809 Hardware Installation Manual page 18

LEDs
Table 1: LED Descriptions
LED
SYS
ALM
VPN_OK
GE0
(10/100/1000)WAN
0
GE0
(10/100/1000)WAN
1
GPS
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
6
Activity Description
Power and System In normal operating mode, after system boots. (typically about
Status 2 minutes)
Off — No power
Green Steady on — Router is reachable, and all interfaces are up
and functioning properly
Green Flashing — Router is reachable, and no interface is in a
failed state
Amber Steady on — Router is unreachable (An external interface
of the router, that prevents the router from being remotely managed,
is in a critical failed state)
Amber Flashing — Router is reachable, but at least one of the
interfaces is in a non-critical failed state (functionality of that
interface is affected)
In bootup mode (during the first 60 seconds after powerup)
Green Steady on — Router is bootingy
Amber Steady on — Router has a system hardware failure
Alarm Input Status Off — Normal operation
Red - Alarm State on the Alarm Input
VPN Off — No VPN tunnel
Steady Green — At least one VPN tunnel is up
Link Status Off — No link
Steady Green — Link is up
Flashing — Transmitting and Receiving data
GPS Status Off — GPS not configured
On — GPS configured
Slow Flash — GPS Acquiring in Standalone GPS
Fast Flash — GPS Acquiring in Assisted GPS
Note Slow Flash is defined as the LED will be on for 0.25
seconds and off for 0.75 seconds.Fast Flash is defined
as the LED will be on for 0.25 seconds and off for 0.25
seconds.
Product Overview