Table of Contents
Advertisement
8. Connect the touchpad cable to the system board and close the latch.
9. Connect the speaker-board cable to the connector on the system board.
10. Connect the speaker cables to the connector on the system board.
11. Connect the I/O board cable to the connector on the system board and close the latch.
12. Connect the fan cable to the connector on the system board.
Next steps
1. Install the
heat sink.
2. Install the fan.
3. Install the
display
assembly.
4. Install the
wireless
card.
5. Install the
M.2 2230 solid-state drive
6. Install the
4-cell battery (64 Wh)
7. Install the
base
cover.
8. Follow the procedure in
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
4-cell battery (64 Wh)
4. Remove the
M.2 2230 solid-state drive
5. Remove the
wireless
card.
6. Remove the fan.
7. Remove the
coin-cell
8. Remove the
I/O
board.
9. Remove the
system
board.
NOTE:
The system board can be removed with the heat sink attached.
10. Remove the
power button
11. Remove the
speaker
board.
12. Remove the speakers.
13. Remove the
display
assembly.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
or the
M.2 2280 solid-state drive
or the
6-cell battery (86
After working inside your
Before working inside your
or the
6-cell battery (86
or the
M.2 2280 solid-state
battery.
or the
power button with fingerprint
, whichever is applicable.
Wh), whichever is applicable.
computer.
computer.
Wh), whichever is applicable.
drive, whichever is applicable.
reader, whichever is applicable.
Removing and installing Field Replaceable Units (FRUs)
77
Advertisement
Table of Contents
