Touchpad; Removing The Touchpad - Dell Inspiron 16 7635 2-in-1 Owner's Manual

Hide thumbs Also See for Inspiron 16 7635 2-in-1:

Table of Contents

Steps

1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.

2. Route the speaker cables through the routing guides on the palm-rest and keyboard assembly.

3. Connect the speaker cables to the connector on the system board.

4. Route the speaker-board cable through the routing guides on the palm-rest and keyboard assembly.

5. Connect the speaker-board cable to the connector on the speaker board.

6. Connect the speaker-board cable to the connector on the system board.

7. Connect the touchpad cable to the system board and close the latch.

8. Connect the keyboard cable to the system board and close the latch.

9. Connect the keyboard-backlight cable to the system board and close the latch.

Next steps

1. Install the

base

cover.

2. Follow the procedure in

Touchpad

CAUTION:

The information in this section is intended for authorized service technicians only.

Prerequisites

1. Follow the procedure in

2. Remove the

base

cover.

3. Remove the

4-cell battery (64 Wh)

About this task

The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.

After working inside your

Before working inside your

or the

6-cell battery (86

computer.

Wh), whichever is applicable.

Removing and installing Field Replaceable Units (FRUs)

Table of Contents