Connecting With Wireless Lan - Panasonic PT-CMZ50 Operating Instructions Manual

4) Perform the detailed setting of [WIRED LAN].
f For details, Refer to "[WIRED LAN]" (x page 117).
Note
f To connect to an existing network, perform after consulting your network administrator.
f Wireless LAN and wired LAN cannot be used in the same segment.
r Factory default setting
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]
Operating the computer
1) Turn on the power of the computer.
2) Perform the network setting following the instruction of your network administrator.
f If the projector is in factory default setting, you can use it as it is if the network setting of the computer is as
follows.
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]

Connecting with wireless LAN

The wireless module (Model No.: AJ-WM50 Series) of the optional accessories is required if you want to use the
network function through the wireless LAN.
Connection example
Preparation and confirmation of the projector
1) Turn on the projector.
2) Attach the wireless module (Model No.: AJ-WM50 Series) of optional accessories firmly into the <USB
(VIEWER/WIRELESS/DC OUT)> terminal.
3) Press the <NETWORK/USB> button to switch to NETWORK input.
f The network input idle screen is displayed. The QR code, login password (a four-digit number that is
automatically generated), PROJECTOR NAME, SSID, IP ADDRESS (WIRELESS) and IP ADDRESS
(WIRED) will be displayed in the idle screen.
f You can also press the <INPUT SELECT> button on the control panel and the input guide is displayed, then
press asqw to switch to NETWORK input.
132 - ENGLISH
Chapter 5 Operation of Function - Network connection
[OFF]
192.168.10.100
255.255.255.0
192.168.10.1
(Blank)
192.168.10.101
255.255.255.0
192.168.10.1
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: AJ-WM50 Series)