Advertisement
Assembling Base & Mounting
Machine
Items Needed
Open-End Wrenches/Sockets 13, 14, 17mm ....1 Ea
Measuring Tape ................................................. 1
Additional Person .............................................. 1
Lifting Equipment ............................................... 1
To assemble base & mount machine:
1.
Attach swivel caster to each front corner
bracket using (4) M8-1.25 x 16 hex bolts and
(4) M8-1.25 lock nuts (see Figure 4).
x 4
Swivel
Caster
Figure 4. Swivel caster attached to front corner
bracket.
2.
Install foot pedal plunger and spring into
each front corner bracket (see Figure 5), and
attach rubber foot with pre-installed hex nut
to bottom of each foot pedal plunger.
Foot Pedal
Plunger
Figure 5. Installing foot pedal plunger and
spring.
Model T33447 (Mfd. Since 07/22)
Qty
Front
Corner
Bracket
Spring
Rubber
Foot
3.
Attach foot pedal to each front corner bracket
using (1) M8-1.25 x 52 shoulder bolt and (1)
M8-1.25 lock nut (see Figure 6).
x 2
Figure 6. Foot pedal attached.
4.
Attach (1) wheel to each rear corner bracket
using (1) M10-1.5 x 56 shoulder bolt and (2)
bearing sleeves (see Figure 7).
Wheel
Figure 7. Wheel installed on rear corner bracket.
5.
Orient
fixed
wheels
tion machine will typically be moved
(see Figure 8). Mounting fixed wheels in
wrong direction will make it difficult to move
mobile base around in small spaces.
(TOP VIEW OF CASTER)
Typical Direction of Movement
CORRECT
Figure 8. Orientation of fixed wheels for easy
machine movement.
Foot
Pedal
x 2
in
same
direc-
INCORRECT
-3-
Advertisement
