Advertisement
MANUAL MODES
This humidifier can be manually programmed
in four ways:
NOTE
Manually setting the Mist Level or Humidity
Setting will cancel any other programmed
functions.
1. MIST INTENSITY CONTROL
• This humidifier has 7 mist intensity levels which
can be manually selected between Low (1) to
High (7).
• The Timer feature and Warm Mist feature can
be used with this setting.
1. Touch or slide your finger along the
MIST LEVEL CONTROL bar
on the control panel to change the intensity.
The intensity level will show on the
display screen.
2. Select another program or touch the
POWER symbol to cancel.
2. HUMIDITY SETTING
• The humidity level can be manually selected
between 30% and 75%RH.
• The Timer feature can be used with this setting.
1. Touch the
HUMIDITY symbol on the
control panel repeatedly to cycle through
30% to 75% RH. The
illuminate on the display screen.
2. When the desired relative humidity level is
displayed, it will flash 5 times before starting.
Once activated, the current humidity level will
return to the display screen.
3. Once the humidity reaches the selected level,
the humidifier will continue to monitor and
regulate as required to maintain that level,
adjusting the mist intensity and turning the
mist off and on. Touch the
symbol to check the selected relative humidity
level.
4. Touch and hold the
until the
HUMIDITY icon disappears
from the display screen or touch the POWER
symbol to cancel.
5. If Warm Mist is needed, it can be selected
when the desired humidity level is above the
room humidity level.
6. If '- -' flashes on the display screen, it is a
reminder that a humidity level has not been
set. It will flash for 5 seconds, then return the
humidifier to Auto mode.
LAH400_ANZ_IB_A19.indd 13
All manuals and user guides at all-guides.com
HUMIDITY icon will
HUMIDITY
HUMIDITY symbol
3. TIMER
• This humidifier has a Timer feature that will turn
the humidifier off after a chosen number of hours.
1. Touch the
TIMER symbol on the control
panel repeatedly to cycle through 1 to 12 hours.
The
TIMER icon will illuminate on the
display screen.
2. When the desired number of hours is displayed,
it will flash 5 times before starting the
countdown. Once activated, the temperature will
return to the display screen.
3. The Timer will begin to count down in 1-hour
increments. The humidifier will automatically
turn off once the chosen time has elapsed.
4. Touch and hold the
the
TIMER icon disappears from the display
screen to cancel this feature.
5. If '- -' flashes on the display screen, it is a
reminder that the timer has not been set. It will
flash for 5 seconds, then return the humidifier to
Auto mode.
NOTE
When the Timer is programmed, the display screen
will alternate every 30 seconds between the current
room temperature and the remaining countdown
time.
4. WARM MIST
• This humidifier has a Warm Mist feature.
A small internal heating element will heat the
water to create a warm vapour.
• The
WARM MIST operates automatically
in Health and Baby modes or can be manually
selected in other programmes.
1. Touch the
WARM MIST symbol on the
control panel to turn on. The
icon will illuminate on the display screen
and warm mist will emit from the mist nozzle
gradually within 10-15 minutes.
2. Touch the
WARM MIST symbol again to turn
off.
NOTE
Warm mist will start after the water has time to heat.
The time will vary depending on factors such as the
temperature of the water in the tank.
IMPORTANT
Any manual operating mode will be cancelled if the
water tank runs empty.
The humidifier will automatically shut off when
there is insufficient water to operate.
TIMER symbol until
WARM MIST
13
27/2/19 8:50 am
Advertisement
