Advertisement
9. Replace the top cover with the nozzle back on
top of the water tank.
10. Connect the power plug to a 230V or 240V
power outlet and switch the outlet on.
POWER symbol will illuminate red.
The
The humidifier is now in Standby mode.
11. Touch the
POWER symbol again to
activate the control panel and display screen.
The humidifier is now switched on and will
automatically begin operation in Auto mode.
IMPORTANT
Water may remain in the water inlet basin even
though the water tank may be empty. However,
once the water in the tank and/or basin is too low
to keep the humidifier running, the humidifier
will stop working. Refill the tank with water.
Do not use the humidifier without water in the
water tank.
NOTE
Take care when removing the water tank from the
base after use as residual water may drip.
LAH400_ANZ_IB_A19.indd 11
All manuals and user guides at all-guides.com
Functions
YOUR BREVILLE HUMIDIFIER
• The control panel lights will dim after
15 seconds if not touched. Touch the centre of
the control panel where the control symbols are
located to wake up the screen.
• The Timer feature can be used in any mode.
• The humidifier will check the humidity level
once every minute.
• Manual adjustment of the Mist intensity control
bar will exit any programmed settings, except
Night mode and manual Humidity setting.
• Touch and hold the
WARM MIST symbol to
turn off the blue light in the water tank.
Repeat to turn back on.
• The humidifier will automatically turn off
if it has insufficient water to operate.
Any programmed operating setting will be
cancelled if the water tank runs empty.
SensAir™ LIVE COMFORT CONTROL
• Your Breville Smart Mist™ Humidifier has
a sensor to detect changes to humidity and
temperature in the surrounding area.
• The SensAir™ can automatically keep the
humidity in "the Sweet Spot" by setting
the appropriate level of relative humidity,
depending on ambient air temperature for
maximum comfort.
OPERATING YOUR HUMIDIFIER
AUTO MODE
•
AUTO mode is the default setting for the
humidifier when turned on from standby.
Auto mode can also be manually selected.
• The Timer feature and Warm Mist feature can
be used with this setting. Mist Intensity cannot
be manually adjusted.
1. Touch the
MODE symbol on the control
panel until the
AUTO icon illuminates on
the display screen.
2. Auto mode automatically adjusts the mist
intensity to regulate the humidity level
between 40-65%RH based on the temperature
within the room.
11
27/2/19 8:50 am
Advertisement
