Table of Contents
Advertisement
Quick Links
Installation
Instructions
"If you have questions, Call 800-GE-CARES
www.GEAppliances.com"
Skill Level: High
Completion Time: 1 to 3 Hours
Proper installation is the responsibility of the installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty. See the Owners Manual for warranty
information.
CAUTION: Before you begin
Read these instructions carefully and
completely.
• IMPORTANT- Save these instructions for
local inspector's use.
• IMPORTANT- Observe all governing codes
and ordinances.
Parts Included
Anti-Tip Bracket and leg leveler
Tools You Will Need
Adjustable wrench
1/4"Nut
driver
Level
Pub. No. 31-10513
4053P493
229C
Self Cleaning Free-Standing
Electric Range
EER2000, EER3000, EER3001, EER3002, JBP10, JBP24, JBP26, JBP30,
JBP35, JBP48, JBP64, JBP66, JBP68, JBP69, JBP71, JBP78, JBP80,
JBP82, JBP90, JBP91, JBP95, JB500, JB600, JB700, JB800
Average
Low
Drill with
1/8" Bit
Phillips
Screwdriver
• NOTE TO INSTALLER- Be sure to leave
these instructions with the consumer.
• OWNER- Keep these instructions for future
reference.
• WARNING- This appliance must be
properly grounded.
Materials Needed
Lag Bolts Anchor Sleeves
(For Concrete Floors Only)
y
Pencil
y y
5/16" Hex Head
Nut driver
1
or visit our website at:
( UL Approved 40 AMP)
3 -Wire Cord
4- Wire Cord
OR
4'long
4'long
Safety
Glasses
Tape Measure
Flat-Bladed
Screwdriver
Advertisement
Table of Contents
Related Manuals for GE JBP10
Summary of Contents for GE JBP10
- Page 1 Average Completion Time: 1 to 3 Hours Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. See the Owners Manual for warranty information. CAUTION: Before you begin •...
-
Page 2: Installation Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS For Your Safety WARNING: To reduce the risk of tipping, the appliance must be WARNING: For personal safety secured by properly installed anti-tip remove house fuse or open circuit bracket packed with the appliance. breaker before beginning installation. -
Page 3: Pre-Installation Checklist
Installation Instructions Pre- Installation Checklist Move the Range Indoors Remove Installation Instructions from EASY INSTALLATION OF YOUR NEW FREE-STANDING RANGE literature pack and read it carefully Before you begin-Read these instructions completely and carefully. Before you begin-Read these instructions completely and carefully. Before you begin-Read these instructions completely and carefully. - Page 4 Installation Instructions Installation Required Clearances See Ilustrations below for all rough-in and spacing dimensions. The range may be placed with 0” clearance (flush) at the back wall and side walls of the cabinet. **30" MIN ***6" MINIMUM DIMENSIONS BETWEEN **15" MIN COOKTOP, WALLS, AND ABOVE THE COOKTOP.
- Page 5 Installation Instructions Electrical Connections Electrical Requirements Making the Electrical Connection Remove the wire cover (on the back of the This appliance must be supplied with the proper range) by removing 5 screws using a 1/4” nut voltage and frequency, and connected to an driver.
- Page 6 Installation Instructions Electrical Connections cont. Attach the green lead NEW CONSTRUCTION AND FOUR below the junction WIRE CORD CONNECTION KIT Ground block with the ground Screw screw that was B3 Complete 4 wire removed earlier. 3 Screws cord kit. Below are step by step Gound Screw and...
- Page 7 Installation Instructions Electrical Connections cont. Connect the outer wires to the outside THREE- WIRE CORD CONNECTION KIT terminals and the center wire to the center terminal. Do not remove the Grounded ground strap Neutral Complete 3 Terminal Grounded Screws wire cord kit. (White) Neutral Terminal...
-
Page 8: Installing The Anti-Tip Bracket
Installation Instructions Installing the Anti-Tip Bracket Installing The Bracket in Wood Locating The Bracket or Concrete The anti-tip bracket, provided with your literature INSTALLATION–WOOD CONSTRUCTION and broiler pan, must be properly installed to prevent the range from tipping. Please refer to a. -
Page 9: Installing The Range
Installation Instructions Installing the Range Storage Drawer Removal CAUTION: The oven door is heavy. You may need help lifting the door Pull the drawer high enough to slide it into the out until it stops hinges slots. Do not lift the door by the handle. - Page 10 Installation Instructions Installing the Range cont. Replacing the Storage Drawer Place the drawer rail on the guides. Push the drawer in until it stops. Stop Lift the front of the drawer and push in until the stops clear the guides. Lower the front of the drawer and push in until it closes.
-
Page 11: Final Check List
Installation Instructions Final Check List Check to make sure the circuit breaker is closed (Reset) or the circuit fuses are replaced. Be sure power is in service to the building. Check to be sure that all packing materials and tape on metal panel (if applicable) under control knobs have been removed. - Page 12 NOTES Pub. No. 31-10513 4053P493 229C...