Makita 2414B Instruction Manual page 5

Interval between vise and guide
plate
4
► 1. Socket wrench 2. Guide plate 3. Move 4. Hex
bolts
The original spacing or interval between the vise and
the guide plate is 0 - 170 mm. If your work requires
wider spacing or interval, proceed as follows to change
the spacing or interval.
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure
it using the hex bolts. The following interval settings are
possible:
35 - 205 mm
70 - 240 mm
CAUTION:
• Remember that narrow workpieces may not be
secured safely when using the two, wider inter-
val settings.
Setting for desired cutting angle
1
2
3
3
► 1. Socket wrench 2. Guide plate 3. Hex bolts
To change the cutting angle, loosen the two hex bolts
which secure the guide plate. Move the guide plate to
the desired angle (0° - 45°) and tighten the hex bolts
securely.
CAUTION:
guide plate is set at the 35 - 205 mm or 70 - 240 mm
position.
CAUTION:
the material is not firmly secured with the vise
because of the cutting angle.
ASSEMBLY
CAUTION:
•
Removing or installing cut-off wheel
For tools with safety guard
► 1. Shaft lock 2. Safety guard 3. Socket wrench
To remove the wheel, raise the safety guard. Press the
shaft lock so that the wheel cannot revolve and use
the socket wrench to loosen the hex bolt by turning it
counterclockwise.
5 ENGLISH
Never perform miter cuts when the
Do not operate the tool when
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
1
1
2
2
3