Installation Guide - Black & Decker BBD20HS Instruction Manual

SET UP & USE

INSTALLATION GUIDE

Read the installation guide carefully to ensure you understand all instructions before
installing the beer kegerator. If after completing the process you are still unsure
whether the beer kegerator has been properly installed, we recommend that you
contact a qualified installer.
NOTE: Allow the beer kegerator to stand in an upright position for at least 8 hours
before plugging in the unit. This is very important! Once the unit is laid on
its side, the refrigerant in the refrigeration system is shifted. If the kegerator
has been placed in a horizontal or tilted position for any period of time,
please wait at least 24 hours before plugging the unit in. The refrigerant in
the refrigeration system needs to stabilize before the unit is turned on.
Installing the Casters
Follow the steps below to install casters:
NOTE: Two of the casters include locking mechanisms to ensure the unit does not
slide on hard floors. These two locking casters should be fastened at the front
end of the unit, with the unlocked casters fastened on the rear end.
1. Empty the inside of the beer kegerator. Once emptied, place the unit down
on it's side. We recommend that you place a piece of cardboard or cloth
underneath the cabinet to prevent dents or scratches.
2. Insert the casters into the holes on the bottom corners of the cabinet. Tighten
each caster by turning the nut clockwise with a wrench (not provided in the kit).
3. Once all four casters have been tightened, stand the cabinet in its upright
position.
Page 9