Table of Contents
Advertisement
1. Park the machine on a leveled surface and make sure that
the engine is completely stopped.
2. Allow the engine to cool.
3. Clean around the oil dipstick with a clean cloth to remove any
debris or oil accumulation.
4. Pull out the dipstick and wipe the metal end clean.
5. Slide the dipstick fully into the dipstick tube and tighten it.
6. Remove the dipstick and check the metal end.
7. If the oil level is too low, slowly pour oil into the dipstick tube to raise
the level of the oil until it reaches the full mark.
8. Replace and tighten the dipstick once the oil has reached the required
levels.
You can adjust the clearance between the air intake housing and the
ground by moving the height adjustment control to your desired position.
Set the height to low (L) for vacuuming hard surfaces such as sidewalks or
driveways and to high (H) for thick, lush turf with a heavy covering of
leaves or clippings. The vacuum will work best when you keep the intake
as close to the ground and is practical for the task that you are performing.
1. To adjust the Intake Housing Height, first stop the engine completely.
2. Tip the machine slightly to the back to the back to take the weight
off the castor wheels.
3. Move the height adjustment control forward to lower the intake
housing. Similarly, to raise the housing, move the height adjustment
control backwards.
4. Return the castor wheels to the ground when the height has been
adjusted to the desired levels.
The RedGum Yard and Garden Vacuum is supplied with two
extra hoses - a Vacuum Hose and a Blowing Hose. Both of these
hoses provide different usage methods and functions, as per your
requirements.
___________________________________________________________________________________
Operation Manual RedGum Garden Vacuum
PRE-OPERATION CHECKS
CHECKING THE OIL
ADJUSTING THE INTAKE HOUSING HEIGHT
OPERATION INSTRUCTIONS
Page 7
RGVAC-0323 Rev 2
Advertisement
Table of Contents
