8.13. Remove the Support metal
1. Remove the screws (×2
2. Remove the Support metal.
8.14. Remove the Hanger metals
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the Support metal. (See section 8.13.)
3. Remove the Hanger metals (L, R) fastening screws (×6
, ×2
each) and remove the Hanger metals (L, R).
4. Remove the V-bar connecting metal-bottoms (L, R) fas-
tening screws (×2
necting metal-bottoms (L, R) and the Bracket covers (L,
R).
).
each) and remove the V-bar con-
8.15. Remove the C1-Board
1. Remove the Hanger metal R. (See section 8.14.)
2. Remove the flexible cable holder fastening screws (×10
).
3. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
4. Disconnect the flexible cable (C10).
5. Remove the screws (×5
8.16. Remove the C2-Board
1. Remove the Support metal. (See section 8.13.)
2. Remove the flexible cable holder fastening screws (×10
).
3. Disconnect the flexible cables (CB6, CB7, CB8, CB9 and
CB10).
4. Disconnect the flexible cables (C20, C21 and C26).
5. Remove the screws (×5
26
) and remove the C1-Board.
) and remove the C2-Board.