Cisco MDS 9000 Series Rack Installation page 4

Installing and Removing the Brackets
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
Figure 1-1
Figure 1-1
1
1 Rack-mounting rail (4x)
2 Shelf bracket (2x)
3 Slider rail (2)
To install the shelf bracket in an EIA rack, follow these steps:
Position a shelf bracket inside the rack-mounting rails as shown in
Step 1
the front of the shelf bracket with the holes in the front rack-mounting rail. Attach the shelf bracket to
the front rack-mounting rail using a minimum of four 12-24 or 10-24 screws.
Note
Step 2 Repeat with the other shelf bracket.
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 3
Cisco MDS 9250i Multiservice Fabric Switch Hardware Installation Guide
1-4
shows the installation of the shelf bracket kit into a four-post EIA rack.
Installing the Shelf Bracket Kit into an EIA Rack
2
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-in. spacing).
3
4
5
4 Crossbar
5 10-32 screws (2x)
Appendix 1 Rack Installation
Figure 1-1. Align the screw holes at
OL-29583-01