Installing The Slide Rails Into A Rack With Round Holes - Cisco 1120 Installation Manual

Chapter 3 Installing and Configuring the Cisco 1120 Secure Access Control Server 4.2
Figure 3-5
The following table describes some of the correct and incorrect ways to insert the adapter pins into the
rack as shown in
1
2
3
After ensuring that the proper mounting holes on the rack upright are selected, repeat
Step 4
rail front-mounting position. Ensure that the slide rail is level.
Extend the slide rail to its fully extended (locked) position. Press the slide extension release levers to
Step 5
release the lock. Move the slide rail in and out throughout its entire range of motion and make certain it
does not bind. If you notice some binding, recheck the mounting positions.
Step 6 Repeat Steps
slide rail.
Proceed to
installation process.

Installing the Slide Rails into a Rack with Round Holes

Installing the slide rails into a rack with round holes requires rack screws (not included in the rack-mount
installation kit). Before you begin the installation, obtain the appropriate rack screws.
OL-19455-01
Correct and Incorrect Adapter Pin Insertion
Correct
1
Figure 3-5.
Correct The multi-pin adapter pins are fully engaged in the rack holes. Also, the
rack hole into which the top pin was inserted aligns with one of the
round RU holes.
Incorrect Note that the multi-pin adapter pins are not fully engaged in the
rack holes.
Incorrect The rack hole into which the top pin was inserted does not align with one
of the RU holes.
2 through 5 for the right slide rail, ensuring that it is parallel and level with the left
Installing the Slide Rails into a Rack with Round Holes, page 3-7
Mounting the CSACS 1120 Series Appliance in a 4-Post Rack
Incorrect
2
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
Incorrect
3
Step 2 at the slide
to continue the
3-7