Advertisement
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
• To replace the Rotating Brush (14) of the nozzle:
Turn the appliance upside down, open the Roller Brush
cover (18) by lifting it. Take the brush out by lifting it on
the right side and moving it out sideways to the right.
• To place the Brush, position the Brush over the Roller
Holder assy (13) then "click" the Brush into place at the
Roller Brush cover and close the Roller Brush cover.
1
FC7020/01 /31 /61 /71 /81
• To replace the Brush Motor (15), Driving belt (12) and
Roller Holder assy (13):
Remove the 10 screws (D) on the bottom of the Nozzle
and push the 3 clicknocks on the front side with a
screwdriver, now the components can be reached.
2
1
• To replace the pump (10):
First remove the Water Tank (3) and Filter assy (4).
Remove the 4 screws (C), and remove the cover.
Now the pump is visible. Remove the clips from the
hoses and the valve and replace the pump.
2
3
Remark:
• You can use the delivered Pin (5) in the small plastic bag
for "unclogging" the little hole on the bottomside of the
Nozzle in case some calcium is present in the hole.
C
C
C C
2-8
Advertisement
