Dimensional drawings:
Installation:
1
4
The product contains bracket for wall mounting and spacers for ceiling mounting.
Step 1: Program the loop address (using a hand-held programmer) before any
installation cables are connected.
Dismantle the luminaire by sliding the mounting part as shown in picture.
Fasten the mounting part (with screws from within) to either wall bracket
(supplied), ceiling (with or without supplied spacers), pendulum, wire or
flag bracket.
Pass the loop cables through the cable glands. Connect the loop
Step 2:
cables to terminal blocks, observe correct polarity.
Tighten the cable tie around the cables.
Connect the battery pack. NB: Do not connect the battery pack before
Step 3:
commissioning of the Delta DA Quad loop is imminent.
Step 4: Carefully slide the sign in place.
Slide the two aluminium parts carefully together.
Step 5:
Fasten the two screws (included) as shown in picture.
Step 6:
Fasten the two screws (included) as shown in picture.
Step 7:
The function of the luminaire must be programmed in Delta DA Quad
Step 8:
using FireWin Explorer.
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
ExiLED LP
Surface mounted
2
5
3
6
7
Note: In case of loop power
disconnection for a period of more
than one month, the battery must be
disconnected.
GB