General / Application - Honeywell LT-32 Installation And User Manual

1

GENERAL / APPLICATION

The purpose of this manual is to provide the user with instructions concerning installation, use and maintenance of the LT-32 / LT-159 Fire Alarm Control Panel
(FACP).
SYSTEM EQUIPMENT
The analogue-addressable LT-32 / LT-159 FACP is compact in size and very easy to install and configure. The system is specifically designed for Agile wireless
equipments. Installation and commissioning time are reduced to a minimum, since only the physical connection to the wireless system gateway is required allowing
the FACP indentifies the sensors, input modules, sirens/flashes installed.
LT-32 is a single loop addressable panel, limited to 32 addressable devices, sensors or modules.
LT-159 allows the connection of up to 159 addressble devices, mainly wireless and a few wired ones dictributed in a maximum of 16 zones.
LT-32 Includes two sounder circuits while LT-159 one sounder circuit.
LT-32 / LT-159 FACP includes Honeywell's Advanced protocol, which maximizes the speed and efficiency of alarm detection, as well as providing maximum
information to the installer. The 4,3" / 109,2 cm (480 x 272 pixel) screen provides an intuitive user interface via its touch screen and menus with quick, and easy system
operation.
The FACP allows configuration from the screen itself.
Due to its size and power, it is the ideal analogue addressable control panel for small sites, where maximum information is required from the installed devices. The
control panel allows the identification of each of the addressable sensors, with different levels of alarm, in order to verify the state of the system, before carrying out
any evacuation or transmission to the alarm receiving station or to the building management system.
Do not try to use the control unit and connected devices without reading this manual!
M-168.1-SERIE-LT-EN / 08.2022
Fire Alarm Control Panel LT-32 / LT-159
5