Honeywell Braukmann T100A Product Data page 12

MV100 ELECTRIC CONTROLLERS T100, T200 THERMOSTATIC CONTROLLERS AND V100 RADIATOR VALVES
Fig. 20. Loosening valve cartridge.
B
A
Fig. 21. Attaching MT100 to valve.
To reinstall cartridge into the valve, use the same process and figures. Perform steps in reverse order. All figure arrows are
backwards (except Fig. 20, arrow A). Proceed as follows:
1. Replace cartridge into chamber (B) and screw end cap onto MT100C (A). See Fig. 23.
2. Close drain cock (C), open ball valve (B), and push handle in (A). See Fig. 22.
3. Turn tool handle cw to screw in cartridge (D), open drain cock to drain chamber of remaining water and steam (C), and
loosen MT100 Cartridge Changer from valve body (B,A). See Fig. 21.
4. Tighten valve cartridge using a 19mm socket wrench (A,B) and replace controller. See Fig. 20.
Home and Building Control
Honeywell Inc.
Honeywell Plaza
P.O. Box 524
Minneapolis MN 55408-0524
62-3048—1 62-3048—1 B.B. Rev. 1-99
B
A
M16274
D
C M16273
Home and Building Control
Honeywell Limited-Honeywell Limitée
155 Gordon Baker Road
North York, Ontario
M2H 3N7
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
Fig. 22. Disconnecting valve cartridge
and draining chamber.
Fig. 23. Removing valve cartridge.
www.honeywell.com/building/components
12
B
A
C
M16275
A
B
M16276
www.honeywell.ca/braukmann/