Pcie Adapter Replacement - Lenovo ThinkSystem SR630 V3 User Manual

Step 3. Install the OCP module.
Notes:
• Ensure that the Ethernet adapter is fully seated and the thumbscrew is securely tightened.
Otherwise, the OCP module will not get full connection and may not function.
• If there is an OCP module installed, when the system is powered off but still plugged in to AC
power, system fan 1 and fan 2 will continue to spin at a much lower speed. This is the system
design to provide proper cooling for the OCP module.
Figure 105. OCP module installation
a. Push the OCP module by its handle on the left until it is fully inserted into the connector on
the processor board.
b. Fully tighten the thumbscrew to secure the adapter.
After you finish
Complete the parts replacement. See
Demo video
Watch the procedure on YouTube

PCIe adapter replacement

Use this information to remove and install a PCIe adapter.
The PCIe adapter can be an Ethernet adapter, a host bus adapter (HBA), a PCIe RAID adapter, a PCIe
interposer adapter, a PCIe solid-state drive, a PCIe GPU, and any other supported PCIe adapter.
Notes:
• Depending on different types, the PCIe adapter might look different from the illustrations in this topic.
• Use any documentation that comes with the PCIe adapter, and follow the instructions in this topic.
"Complete the parts replacement" on page 246.
.
Chapter 5 Hardware replacement procedures
169