Pcie Adapter Replacement - Lenovo ThinkSystem SD650 V3 User Manual

After you finish
1. Install the tray cover. See
2. Install the tray into the enclosure. See
3. Connect all required external cables to the solution.
Note: Use extra force to connect QSFP cables to the solution.
4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all
nodes are ready to be powered on.

PCIe adapter replacement

Use the following procedures to remove and install a PCIe adapter.
Remove a PCIe adapter
Use this information to remove a PCIe adapter.
About this task
Attention:
• Read "Installation Guidelines" on page 33
work safely.
• Turn off the corresponding DWC tray that you are going to perform the task on.
• Disconnect all external cables from the enclosure.
• Use extra force to disconnect QSFP cables if they are connected to the solution.
Note: The following illustration might differ slightly from your hardware, but the removal method is the same.
Watch the procedure
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Step 1. Make preparations for this task.
a. Remove the tray from the enclosure. See
40.
b. Remove the tray cover. See
c. Remove the PCIe riser assembly. Depending on your configuration, see
assembly (ConnectX-6)" on page
200)" on page
Step 2. Remove the screw; then, grasp the adapter by its edges and carefully pull it out of the PCIe riser-
cage.
"Install the tray cover" on page
"Install a DWC tray in the enclosure" on page
and "Safety inspection checklist" on page 34
.
"Remove the tray cover" on page
119,
128, or "Remove a PCIe riser assembly (ConnectX-7 NDR 400)" on page
44.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove a DWC tray from the enclosure" on page
43.
"PCIe riser assembly replacement (ConnectX-7 NDR
.
Chapter 5 Hardware replacement procedures
42.
to ensure that you
"Remove a PCIe riser
138.
115