Remove the backing paper from the
rubber.
Stick the rubber to the back of the
soundbar.
NOTE: Ensure the surface is clean
prior to sticking the rubber to the
back of the soundbar.
Leave a 0.4 inch (9 mm) gap between the wall and the screw's head. Lift the soundbar over the heads of the screws and
slot into place.
Connect Power
Risk of product damage!
- Ensure that the power supply voltage corresponds to
the voltage printed on the back or the underside of the
unit.
- Before connecting the AC power cord, ensure you have
completed all other connections.
• Connect the mains cable to the AC~ Socket of soundbar
and then into a mains socket.
Standby/ON
When you first connect the soundbar to the mains socket, the main unit will be in Standby mode.
-
Press the
button on the soundbar to switch the unit ON.
-
Press the
button again to switch the unit back to STANDBY mode. The indicator will light up red.
-
Disconnect the mains plug from the mains socket if you want to switch the unit OFF completely.
-
If a TV or an external device is connected, the unit will switch on automatically when the TV or the external
device is switched on.
Drill 2 parallel holes (Ø 3-8 mm each according to wall type) in the
wall. The distance between the holes should be 2.33 feet (711 mm).
Firmly fix 1 dowel into each hole in the wall if necessary.
Basic Operation
Dowel
Solid wall (solid brick, solid
concrete, solid wood, solid
wooden battens)
Drywall, plaster wall, lath
wall, etc.
14