Set A Static Ip Address - ABB VSN730 Product Manual

inverters can be discovered using the Find button to the right of the Modbus RTU interface they are
connected to.
In the Modbus Device Discovery window click Start and then wait for it to find all your connected
inverters. Once it finds all devices, click Stop and then click Close to close the window and return
to device configuration. There is no need to wait for it to finish.

Set a static IP address

Setting a Static IP is only necessary if required by your network. In almost all cases you can skip
this section.
1. Obtain Static IP address information for the site.
2. Select the Network tab. Set the Type (Network Connection Type) field to Static. The page
allows you to type in the following information:
•
•
•
•
3. Press Update at the bottom of the page.
The data logger needs to be rebooted before network changes take affect.
IP address
Subnet Mask
Gateway
DNS (put a single space between primary and secondary DNS servers)
VSN730 System Monitor Product Manual
15 -
-