Capacities - Hitachi ZAXIS 250LC-7 Operator's Manual

This section is divided into 2 sections, lifting capacities and machine capacities.
The section regarding lifting capacities provides information on capacities when the machine is used for lifting
applications. For general information regarding safety precautions during lifting operation, please read the information
provided in the machine's operator's manual and follow local regulations and instructions.
The section with information regarding machine capacities is intended for applications other than lifting operation. It
provides information relevant for the selection of suitable attachments, matching the machine's capacities. Please take
into account the machine's intended use when selecting attachments to avoid misuse and potential damage to the
machine.
Conditions related to Lifting Capacities
� Lifting capacity of the ZX series does not exceed 75 %
oftipping load with the machine on rm, level ground or
87%of full hydraulic capacity. (ISO 10567)
� * Indicates load limited by hydraulic capacity.
How to Use This Lifting Capacities Chart
� Net lifting capacities are equal to the values obtained by
deducting the ATT mass from the values described in the
table.
� Capacities shown are metric measure.
Symbols Used in This Book
A: Load radius (m)
B: Load point height (m)
C: Lifting capacity (kg)
Value at the maximum load radius
D:
(lifting capacity) (kg)
Value at the maximum load radius
E:
(reach) (m)
Rating over-front
Rating over-side or 360 degrees

CAPACITIES

9-1
A : Load radius
B : Load point height
C : Lifting capacity
MDC1-LC-031-1