Assembly Instructions - Black & Decker BD17206 Instruction Manual

ASSEMBLY INSTRUCTIONS

1 . Check that the control knob (G) for the
gas supply system is turned to the 'OFF'
position before starting any assembly.
2 . Attach handle (C) to the lid (A) using 2 pcs
washers (BB) and 2 pcs M6 x 16 screws
(AA).
BB
AA
G
C
A
3 . Remove the rubber cap on the electronic
igniter (H) by unscrewing and slide battery
(D) into the battery slot. Make sure the
positive side of the battery faces outwards.
Screw the electronic igniter cap (H) over
the battery tightly.
WARNING
• Battery acid leakage can cause personal
injury and cause damage to the product and
surrounding property. If battery leakage
occurs, thoroughly wash any affected skin,
making sure to keep battery acid away from
eyes, ears, nose and mouth. Immediately
wash any clothing or other surface that
comes in contact with leaked battery acid. If
a chemical burn occurs or if irritation persists,
seek medical attention. Dispose according to
Local, State, or Federal regulations.
• Battery is to be inserted based on
instructions provided in this manual
• NEVER dispose of batteries in fire, as they
may leak and explode.
• Promptly remove exhausted batteries from
product.
• Remove batteries before extended storage.
4 . Put the 20 lb. propane gas tank (not
included) into the tank holder (E). Turn
the wing screw on the outside of the tank
holder (E) clockwise to tighten the tank into
the tank holder.
H
D
10