Installing The Rubber Feet (If Using Option-B); Wall Mounting (If Using Option-C) - Horizon Fitness ACUSTIC O HAV-S2860 Operating Instructions Manual

Installing the Rubber Feet (if using option-B)

You can extend the height of the unit.
Note:
Ensure the surface is clean prior to sticking the rubber foot to the bottom of the unit.
1. Turn the unit upside down.
2. Remove the backing paper from the rubber foot.
3. Stick the rubber foot to the bottom of the unit as shown in the illustration below.

Wall Mounting (if using option-C)

Note:
 Installation must be carried out by qualified personnel only.
Incorrect assembly can result in severe personal injury and
property damage (if you intend to install this product yourself,
you must check for installations such as electrical wiring and
plumbing that may be buried inside the wall). It is the installer's
responsibility to verify that the wall will safely support the total
load of the unit and wall brackets.
 Additional tools (not included) are required for the installation.
 Do not overtighten screws.
 Keep this instruction manual for future reference.
 Use an electronic stud finder to check the wall type before
drilling and mounting.
1. Drill 4 parallel holes (Ø 3-8 mm each according to wall type) in
the wall. The distance between the holes should be 764 mm.
- Firmly fi x 1 dowel into each hole in the wall if necessary.
2. Tighten the wall mount brackets on the wall with screws and
screwdriver (not included). Make sure the they are securely
installed.
3. Loosen the screws at the back of the unit for 3 mm. Lift the unit
onto the wall mount brackets and slot into place.
20