Basic Linked Shooting - Canon WFT-E7 Ver.2 Instruction Manual

Basic Linked Shooting

Shoot with the master camera linked to slave cameras as follows.
Set up the master camera.
1
Configure the settings on the master camera
following steps 1-3 on the preceding page, and
then select [Master].
Select [Auto connect].
2
For [Manual connect] instructions, see page 75.
Set up the slave cameras.
3
On the slave cameras, select [OK].
Check the number of slave cameras.
4
On the master camera LCD monitor, the number of
slave cameras detected is displayed.
Establish the connection.
5
On the master camera and all slave cameras,
select [OK].
A screen confirming the connection of the camera
is displayed.
Settings information is stored on the cameras. It is
not stored on the transmitters.
71