NLTroubleshooting
Malfunction
Vibration and movement
device during
the centrifuge
run.
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
i-DOS i-DOS
cannot be pressed
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
52
Cause and Troubleshooting
Secure the device feet. of the
▶
→ "Adjusting the device", Page 17
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
Load recognition is active.
No error, no action necessary.
▶
Remark:The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric
▶
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, reduce the
▶
basic dosing amount
→ Page 37 .
When dosing manually, reduce the amount of
▶
detergent for the next wash with an equal load.
Intelligent dosing is not possible for this program.
No error - no action required.
▶
→ "Start program with intelligent dosing system",
page 35
Program progress does not allow intelligent dosing. No
solution possible.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
is activated.
Select a suitable program for the type of fabric.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶